PRODUCT NAME Chlorinated Rubber Coat SLJB01
BRIEF One Pack paint made from acrylic acid modified chlorinated rubber resin, modifier，pigments and extenders
FEATURES
-Excellent anticorrosion and weather resistance
-Excellent salt spray resistance and ageing resistance
-Excellent resistance to pulverization and crack
-Wide range use of paint coating
-Good compatibility with various coatings
RESISTANCE GUIDE
HEAT RESISTANCE This product should not be used in high temperature environment
WEATHERABILITY Good gloss and colour retention when exposed
SOLVENTS This product should not be direct contact with various organic solvents
CHEMICAL Well
SALTS Resists splash and spillage of neutral and alkaline salts
WATER Resists splash and spillage of fresh and salt water, but soak
ABRASION Excellent
USES: Widely used on steel and concrete internal and external area as top coat in all kinds of weather conditions. Dry quickly, can be used under low temperature conditions.
TYPICAL PROPERTIES AND APPLICATION DATA
COLOR            Colors
DENSITY          1.25g/cm3
SOLIDS BY VOLUME 50%
SOLIDS BY WEIGHT 68%
SPREADING RATE   8m2/kg (50um DFT)
DRYING TIME(23℃) Touch 1 Hr Handle 24 Hr
OVERCOAT INTERVAL(23℃) Min 4 Hr Max none
PACKAGING        22kg
DIRECTIONS Before using stir or using dynamic mixer mixing two components completely.
Rate of cure will vary depending on temperature and other factors such as ventilation, film thickness, humidity, thinner. The temperature of stir will >15℃, otherwise thinner should be added for needed viscosity after stir. Overmuch thinner will lead sag and slow cure rate, thin film, thinner should beadded after mixed. Practical spreading rates may be reduced 5%—25% for wastage of different application conditions.
APPLICATION

STEEL: Steel surface must be prepared by abrasive blast cleaning to ISO Standard Class Sa2.5 or power tool cleaning Class St3. Weld and the damage parts processing to Sa2.5 level or St3 level.
Don’t apply at temperatures below 5℃ or above 40℃. Don’t apply at relative humidity above 85% or when the surface is less than 3℃ above the dew point.
Don’t apply if there is fog, rain, snow or strong wind.
BRUSH/ROLLER: Suitable for small areas only. Apply even coats of the mixed material to the prepared surface. Thin if necessary with up to 0-15% with Epoxy Thinner. Additional coats may be required to attain specified thickness.
CONVENTIONAL SPRAY: Thinning is not normally required, however 0-15% of Epoxy Thinner X-2 can be added.
AIRLESS SPRAY: Thinning is not normally required, however 0-5% of Epoxy Thinner X-2 can be added. Pump ratio is 23:1 or 32:1 and fluid tip is 0.38-0.43 mm.
Overcoating: Aged coating should be tested for lifting by a method such as ‘X’cut or crosshatch methods. If it lifts, remove it. The surface must be free of oil, grease and other contaminants.
CLEAN UP: with Epoxy Thinner X-2

SAFETY: Pay attention to the safety precautions before and after using this product. Users should comply with the provision of the respective country or local government. It’s dangerous or deadly to eating it. To avoid inhalation of thinner steams and spray mists.
Use protective wears correctly; the skin and eyes should avoid contacting it. Use with good ventilation. This product is flammable. All sources of ignition must be eliminated in, or near the working area. DO NOT SMOKE. Fight fire with foam, CO2 or dry chemical powder. On burning will emit toxic fumes.
Notes: The data in the manual is get from standard experiments and may be vary from different conditions in use. Please refer to the latest manual if the data is altered and we would not inform specially.